[. . . ] TURBINE POWERED HUMIDIFIER Model: TB-1 The TurboMistTM distributes moisture via a rotating foam system powered by air movement in the furnace plenum. [. . . ] Shim with thin metal washers at the front flange as necessary. Figure 2 Figure 3 Figure 4 Page 2 Figure 5 REASSEMBLE HUMIDIFIER: (FIGURES 6 & 7) 1. Place evaporator assembly and pan into humidifier body making sure evaporator shaft fits into drive hub. Attach float and arm assembly by inserting bracket into mounting hole in the body of humidifier. Insert #8-32 hex head screw provided in bagged hardware and tighten into place. (Figures 7 & 8) INSTALLATION OF SADDLE VALVE ON COPPER TUBE (FIGURE 8) CAUTION: Do not turn handle before or while installing the "saddle tapping valve. " Be sure the piercing lance does not protrude beyond the rubber gasket. Assemble the "Saddle Tapping Valve" on copper tube with enclosed bolt and nuts. Make the water connection to the outlet of the "Saddle Tapping Valve. " 4. After completing all installation steps turn the handle counter-clockwise to open the valve. [. . . ] No checks, cash, COD's, or money orders will be accepted. Accessory Parts List Float Valve Assy Evaporator Assembly Saddle Valve Assembly Turbine Assembly 46242700 46244100 46007300 46235700 Page 4 [. . . ]